纳米结构CuO为敏感电极的阻抗谱型NO2传感器
Impedencemetric-Type NO2 Sensor with CuO Nano-Structured Sensing Electrode
作者单位
王 岭 河北联合大学化学工程学院唐山 063009 
郝增川 河北联合大学化学工程学院唐山 063009 
戴 磊 河北联合大学化学工程学院唐山 063009 
李跃华 河北联合大学化学工程学院唐山 063009 
吴印林 河北联合大学化学工程学院唐山 063009 
崔广华 河北联合大学化学工程学院唐山 063009 
摘要: 以浸渍技术制备的纳米CuO颗粒作敏感电极,以YSZ作为固体电解质制备了阻抗谱型NO2传感器。采用XRD、SEM对NO2传感器敏感材料的相组成和微观形貌进行了表征,应用电化学工作站测试了传感器的敏感性能。结果表明:浸渍法制得的CuO颗粒均匀分布在电解质的多孔层内,粒径在200 nm左右。在450~550 ℃,传感器对NO2有良好的敏感性,在0.1 Hz总阻抗|Z|=(Z′2+Z″2)/(1/2)与NO2浓度(0~200 mL·m-3)呈良好的线性关系。传感器的固有响应时间为50 s,共存的O2和CO2气体对传感器敏感性能几乎没有影响。
关键词: 阻抗谱型NO2传感器  浸渍技术  CuO纳米颗粒  YSZ
基金项目: 
Abstract: An impedancemetric NO2 sensor was fabricated with infiltrated nano-structured CuO as sensing electrode and YSZ as solid electrolyte. The phase composition and microstructure of sensing material of the sensor were characterized by XRD and SEM. NO2 sensing performance of the sensor was investigated by electrochemical measurement. The results indicate that the CuO particles uniformly distribute in porous YSZ layer and their sizes are around 200 nm. The sensor shows good response to NO2. The total impedance values |Z|=(Z′2+Z″2)/(1/2) of the device at 0.1Hz are found to vary almost linearly with the NO2 concentrations from 0 to 200 mL·m-3 at 450~550 ℃. The response time of the sensor is about 50 s and sensing performance to NO2 of the device are hardly affected by co-existent O2 and CO2.
Keywords: impedancemetric-type NO2 sensor  infiltration technology  CuO nanoparticles  YSZ
 
摘要点击次数:  1444
全文下载次数:  1990
王 岭,郝增川,戴 磊,李跃华,吴印林,崔广华.纳米结构CuO为敏感电极的阻抗谱型NO2传感器[J].无机化学学报,2012,28(1):81-87.
查看全文  查看/发表评论  下载PDF阅读器
Support information: