球钯材料填充柱中氢-氘交换的计算机模拟
Simulation of Hydrogen-Deuterium Exchange Behavior in the Sphere Pd-Filled Column
作者单位E-mail
曾景晖 四川大学原子核科学技术研究所, 辐射物理及技术教育部重点实验室, 成都 610064
中国科学院高能物理研究所多学科中心, 北京 100049 
 
宋江峰 中国工程物理研究院, 绵阳 621900  
杨远友 四川大学原子核科学技术研究所, 辐射物理及技术教育部重点实验室, 成都 610064  
侯氢 四川大学原子核科学技术研究所, 辐射物理及技术教育部重点实验室, 成都 610064  
罗德礼 中国工程物理研究院, 绵阳 621900  
廖家莉 四川大学原子核科学技术研究所, 辐射物理及技术教育部重点实验室, 成都 610064  
杨吉军 四川大学原子核科学技术研究所, 辐射物理及技术教育部重点实验室, 成都 610064  
唐军 四川大学原子核科学技术研究所, 辐射物理及技术教育部重点实验室, 成都 610064  
刘宁 四川大学原子核科学技术研究所, 辐射物理及技术教育部重点实验室, 成都 610064 nliu720@scu.edu.cn 
王东琪 中国科学院高能物理研究所多学科中心, 北京 100049 dwang@ihep.ac.cn 
摘要: 本文结合球体颗粒交换模型(SPEM)与气-固表面交换模型设计了氢-氘交换反应模型,采用FORTRAN语言进行计算机编程模拟,研究了钯材料粒径、分离柱长度、填料密度、气体流速和温度等因素对氢氘交换反应的影响。结果表明:通过降低气体流速,增大金属材料目数、填料密度、交换柱长,以及升高温度,可以提高交换速率;而在满足一维速率方程的条件下,柱径的大小不影响交换反应过程。
关键词:   氢-氘交换  模拟  FORTRAN
基金项目: 国际磁约束聚变能计划专项(No.2010GB112001);国家基础科学人才培养基金·特殊学科点 (No.J1210004)资助项目。
Abstract: A hydrogen-deuterium exchange reaction model was constructed by combining the Sphere Particle Exchange Model (SPEM) and the Gas-Solid Surface Exchange Model, and programmed in terms of numerical algorithm using FORTRAN language to simulate the H-D exchange reaction in a column filled with palladium (Pd) particles. This model was then used to study the influence of the properties of Pd material, including its size and density in the column, the length of the column, the velocity of the gas flow and temperature, etc., on the exchange reaction. The calculation show that low flow velocity, high density and small size of Pd particles, longer column and higher temperature may accelerate the exchange reaction of D by H, while the diameter of column has no effect when the diffusion model used here holds.
Keywords: palladium  hydrogen-deuterium exchange  simulate  FORTRAN
投稿时间:2013-01-21 修订日期:2013-05-28
摘要点击次数:  1770
全文下载次数:  1846
曾景晖,宋江峰,杨远友,侯氢,罗德礼,廖家莉,杨吉军,唐军,刘宁,王东琪.球钯材料填充柱中氢-氘交换的计算机模拟[J].无机化学学报,2013,29(8):1626-1632.
查看全文  查看/发表评论  下载PDF阅读器
Support information: