γ射线辐照法制备CdS纳米棒及性能表征
CdS Nanorods:Preparation by γ-irradiation Method and Characterization
作者单位E-mail
赵兵 上海大学环境与化学工程学院, 上海, 200444  
张海娇 上海大学环境与化学工程学院, 上海, 200444  
王昊博 上海大学环境与化学工程学院, 上海, 200444  
焦正 上海大学环境与化学工程学院, 上海, 200444 zjiao@shu.edu.cn 
吴明红 上海大学环境与化学工程学院, 上海, 200444  
摘要: 在pH=3的酸性条件下,以硫酸镉和硫代乙酰胺(TAA)为反应前驱体,采用十六烷基三甲基溴化铵(CTAB)自组装形成的管状胶束(PVAC)为模板,通过γ射线辐照法成功合成了CdS纳米棒,并通过XRD、UV-Vis、SAED、TEM和PL等技术对反应中间产物及最终产物进行了表征。研究表明,该方法在Cd2+浓度为0.015mol·L-1、辐照剂量为15~20kGy时,可获得直径在100nm以下,长度在3μm以上的CdS纳米棒;并且较低的辐照剂量和反应物浓度有利于获得较大长径比的CdS纳米棒。
关键词: CdS  纳米棒  十六烷基三甲基溴化铵(CTAB)  γ射线
基金项目: 上海市教委重点学科(No.T0105);上海市教委重点项目(No.07ZZ11);上海市高校选拔培养优秀青年教师科研专项基金;上海大学创新基金资助项目
Abstract: CdS nanoarods have been synthesized by using Cetyltrimethyl Ammonium Bromide(CTAB) as the soft template underγ-irradiation through the reaction of cadmium sulphide(CdSO4·8/3H2O) and thiacetamide(TAA) in acidic condition for pH value of 3.The physical and chemical properties and the structure of CdS nanorods were characterized by XRD,UV-Vis,SAED,TEM and PL.The results indicate that CdS nanorods synthesized by soft template method are below 100 nm in diameter and above 3 nm in length,and low irradiative dosage and concentration of reactants can accelerate the formation of CdS nanorods with higher length-to-diameter factor about 30:1 range.
Keywords: CdS  nanorods  cetyltrimethyl ammonium bromide(CTAB)  γ-irradiation
投稿时间:2007-10-29 修订日期:2008-01-14
摘要点击次数:  1665
全文下载次数:  1901
赵兵,张海娇,王昊博,焦正,吴明红.γ射线辐照法制备CdS纳米棒及性能表征[J].无机化学学报,2008,24(3):393-397.
查看全文  查看/发表评论  下载PDF阅读器
Support information: